UTC RETAIL 3170 Series Installationsanleitung PDF herunterladen (Seite 3)

Site Specifications and Power Requirements

Power Requirements

Voltage

Frequency

Current (typical)

120 VAC

60 Hz

0.5A current

Site Wiring

A dedicated, unswitched power line is recommended. The AC outlet

should be close to the 3170 Series. Do not use extension cords.

Environmental Conditions

Temperature

Constant operation at or near the temperature limits stated below

should be avoided. Do not exceed the limits shown. Leave at least

1” clearance on the sides and rear of the 3170 to allow for air

circulation.

Operating temperature:

Storage temperature:

0°C to 40°C (32°F to 104°F)

-20°C to 60°C (-4°F to 140°F)

Humidity

Constant operation at or near the humidity limits stated below

should be avoided. Do not exceed the limits shown.

Humidity Up to 90% non-condensing

Airflow Requirements

The ambient air temperature must not exceed 40°C (104°F).

Do not block the air vents on either side of the 3170 Series

Workstation. Airflow through these vents is required for system

cooling.

Do not install the 3170 Series in a location not having sufficient

ventilation. Leave several inches of clearance on both sides where

the air vents are located.

AC Power Line and Data Line Transient Protection

The 3170 Series is a modern computer that can interface with a large variety of peripherals. This complete POS

system represents a significant financial investment for your site. As such, it must be protected against energy

transients (lightening strikes, switching transients), complete power loss or brownouts as you would protect any

piece of computer equipment. UTC RETAIL has a large variety of power and data line conditioner equipment and

uninterruptible power supplies (UPS) that can be sized for your system; contact your UTC RETAIL representative

for information.

1 2 3 4 5

Keine Kommentare

UTC RETAIL 3170 Series Installationsanleitung Seite 3